Pre-Operation Check Set-up

WARNING: This page is about a different car, the 2013 Honda Fit, 2012 Honda Fit, 2011 Honda Fit, 2010 Honda Fit, and 2009 Honda Fit. However, it is still accessible from the selected car via links, so may be relevant.

Make sure all the components of the front passenger's seat are correctly installed.
Position the front passenger's seat to the rear most position. Adjust the seat-back to the forward most position. Do not move the seat from this position until the operation check is completed.
Position the front passenger's seat all the way rearward. Adjust the seat-back all the way forward. Do not move the seat from this position.
Make sure nothing is on the front passenger's seat, including aftermarket seat covers or mats.
Make sure there is nothing in the front passenger's seat-back pocket.
Keep the windows closed.
Do all initialization procedures, except test-driving, in the service bay.
Make sure the vehicle is on level ground.
Turn the heater and the A/C off.
Do not touch the front passenger's seat during the operation check.
Do not expose the front passenger's seat to sudden temperature changes.
Make sure all aftermarket devices such as amplifiers, fluorescent light, air purifiers, CB, or HAM radios, etc. are turned off.

Drive the vehicle, accelerate to 22 mph (36 km/h), then stop on level ground.
Make sure the ignition switch is in LOCK (0).
Connect the HDS to the data link connector (DLC) (A).

Fig 1: Identifying Data Link Connector
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Turn the ignition switch to ON (II).
Make sure the HDS communicates with the vehicle and the SRS unit. If it does not communicate, troubleshoot the DLC circuit (see DLC CIRCUIT TROUBLESHOOTING ).
From the HDS Main Menu, select SRS, then Inspection. In the Inspection Menu, select AFTER REPLACING FRONT PASSENGER'S SEAT COMPONENT(S). Follow the prompts until the ODS unit operation check has been completed.
Turn the ignition switch to LOCK (0).
Disconnect the HDS from the DLC.