LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2012 >> Cube Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 30 (SRS (Supplemental Restraint System)) >> Front Impact Sensor Replacement >> Removal

Front Impact Sensor Replacement: Removal

WARNING: This page is about a different car, the 2013 Honda Fit, 2012 Honda Fit, 2011 Honda Fit, 2010 Honda Fit, and 2009 Honda Fit. However, it is still accessible from the selected car via links, so may be relevant.
  1. Do the battery terminal disconnection procedure (see BATTERY TERMINAL DISCONNECTION AND RECONNECTION ), then wait at least 3 minutes before starting work.
  2. Remove the front grille cover (see FRONT GRILLE COVER REPLACEMENT ).
  3. Remove the TORX bolt (A) using a TORX T30 bit, then remove the front impact sensor (B).
    Fig 1: Identifying Front Impact Sensor & Bolts
    G05960632Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Disconnect the left or right engine compartment wire harness 2P connector (C).
    Fig 2: Identifying Engine Compartment Wire Harness 2P Connector
    G05960633Courtesy of AMERICAN HONDA MOTOR CO., INC.
scientia non olet · About LEMON Manuals