DTC Fx-11: ("X" Can Be 0 Thru 9 Or A Thru F) Airbags And/Or Tensioners Deployment Recorded
WARNING: This page is about a different car, the 2013 Honda Fit, 2012 Honda Fit, 2011 Honda Fit, 2010 Honda Fit, and 2009 Honda Fit. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- Before doing this troubleshooting procedure, find out if the vehicle was in a collision. If so, verify that all the required components were replaced with new components, of the correct part number, and that they were properly installed. (See COMPONENT REPLACEMENT/INSPECTION AFTER DEPLOYMENT ).
- Before doing this troubleshooting procedure, review SRS PRECAUTIONS AND PROCEDURES , General Troubleshooting Information (see DTC (DIAGNOSTIC TROUBLE CODES) and BATTERY TERMINAL DISCONNECTION AND RECONNECTION .
- Refer to the DTCs shown:
- DTC F1-11: Driver's airbag, left side curtain airbag, and/or driver's seat belt tensioner deployed.
- DTC F2-11: Front passenger's airbag, right side curtain airbag, and/or front passenger's seat belt tensioner deployed.
- DTC F3-11: Driver's side airbag, left side curtain airbag, and/or driver's seat belt tensioner deployed.
- DTC F4-11: Front passenger's side airbag, right side curtain airbag, and/or front passenger's seat belt tensioner deployed.
- DTC F5-11: Both or only one side curtain airbag and seat belt tensioner deployed.
- DTC F6-11: Both or only one side curtain airbag and seat belt tensioner deployed.
When any airbags or tensioners have deployed, go to Component Replacement/Inspection After Deployment. (See COMPONENT REPLACEMENT/INSPECTION AFTER DEPLOYMENT ).