LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2012 >> Cube Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 30 (SRS (Supplemental Restraint System)) >> Airbag and Tensioner Disposal >> Deploying Airbags In the Vehicle >> Side Curtain Airbag

Side Curtain Airbag

WARNING: This page is about a different car, the 2013 Honda Fit, 2012 Honda Fit, 2011 Honda Fit, 2010 Honda Fit, and 2009 Honda Fit. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the cargo area side trim (see TRIM REMOVAL/INSTALLATION - REAR SIDE AREA ).
  2. Disconnect the floor wire harness 2P connector (A) from the side curtain airbag.
    Fig 1: Identifying Floor Wire Harness 2P Connector
    G05960608Courtesy of AMERICAN HONDA MOTOR CO., INC.
scientia non olet · About LEMON Manuals