Rotor Slip Ring Test

WARNING: This page is about a different car, the 2013 Honda Fit, 2012 Honda Fit, 2011 Honda Fit, 2010 Honda Fit, and 2009 Honda Fit. However, it is still accessible from the selected car via links, so may be relevant.

Measure the resistance between the slip rings (A).
- If the resistance is not within the standard, replace the rotor assembly.
  Coil (rotor) resistance
  
  Standard: 2.1-2.3 Ω at 68°F (20°C)
  
  Fig 1: Checking Continuity Between Slip Ring, Rotor & Rotor Shaft
  Courtesy of AMERICAN HONDA MOTOR CO., INC.
Check for continuity between each slip ring (A) and the rotor (B) and the rotor shaft (C).
- If there is no continuity, replace the rear housing assembly.
- If there is continuity, replace the rotor assembly.