Rear Evaporator Temperature Sensor Replacement

WARNING: This page is about a different car, the 2013 Acura MDX, 2012 Acura MDX, 2011 Acura MDX, and 2010 Acura MDX. However, it is still accessible from the selected car via links, so may be relevant.

SRS components are located in this area. Review the SRS component locations (see COMPONENT LOCATION INDEX ), and the precautions and procedures (see PRECAUTIONS AND PROCEDURES ) before doing repairs or service.

Remove the center console (see CENTER CONSOLE REMOVAL/INSTALLATION ).
Disconnect the 2P connector (A) from the rear evaporator temperature sensor (B), then detach the connector clip (C). Remove the self-tapping screw and the rear evaporator temperature sensor from the rear HVAC unit.

Fig 1: Locating 2P Connector, Rear Evaporator Temperature Sensor And Connector Clip
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the sensor in the reverse order of removal.