DTC 2706: Gyro Diag ECU Temp XX °C

WARNING: This page is about a different car, the 2013 Acura MDX, 2012 Acura MDX, 2011 Acura MDX, and 2010 Acura MDX. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Check the vehicle battery condition first (see BATTERY TEST ).
This navigation DTC sets when the audio-navigation unit YAW sensor's temperature is out of its specified range.
Check any official Honda service website for more service information about the navigation system.
Before you troubleshoot, make sure to follow the general troubleshooting information (see GENERAL TROUBLESHOOTING INFORMATION ).
Do this test only when the vehicle cabin temperature is between -4 °F (-20 °C) and 158 °F (70 °C).

Clear the hard error code (see HOW TO CLEAR ERROR HISTORY ).
Turn the ignition switch to LOCK (0), and then back to ON (II).
Go into the Diagnostic Menu, and select the Self-Diagnosis Mode in the Select Diagnosis items menu (see SYSTEM DIAGNOSTIC MODE ).
Check the System Links.
Is the Yaw Sensor icon red?

YES -Replace the audio-navigation unit (see AUDIO-NAVIGATION UNIT REMOVAL/INSTALLATION ).

NO -Intermittent failure, the system is OK at this time. If the vehicle repeatedly comes back with the DTC, replace the audio-navigation unit (see AUDIO-NAVIGATION UNIT REMOVAL/INSTALLATION ).