With navigation
WARNING: This page is about a different car, the 2013 Acura MDX, 2012 Acura MDX, 2011 Acura MDX, and 2010 Acura MDX. However, it is still accessible from the selected car via links, so may be relevant.
The commands for pairing the phone can either be selected using the interface dial or by using the voice recognition system (TALK and BACK buttons).
NOTE:
The navigation system can pair up to six phones. If you try to pair a seventh phone, a message appears that prompts you to delete one of your existing phones.
- Turn the ignition switch to ACC (I), and make sure the phone you are pairing is on and in its discovery mode.
- Press the INFO button, and turn the interface dial to select Cellular Phone, then press ENTER.
- Move the interface dial down to select Phone Setup.
- Select Setup Bluetooth phone, and press Enter.
- Select Pair Phone, then press enter.
- When a four-digit pass key number appears on the screen, wait until prompted by the phone, then enter the pass key into your cell phone.
- Once the phone is successfully paired, the screen displays "The pairing was successful."