Vanity Mirror Light Test/Replacement

WARNING: This page is about a different car, the 2013 Acura MDX, 2012 Acura MDX, 2011 Acura MDX, and 2010 Acura MDX. However, it is still accessible from the selected car via links, so may be relevant.

Open the sunvisor.
Remove the sunvisor (see SUNVISOR REMOVAL/INSTALLATION ).
Disconnect the 2P connector (A) from the vanity mirror light.
Vanity Mirror Light: 2 W

Fig 1: Identifying 2P Connector, Mirror Cover, Lens And Bulb
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Check for continuity between terminals No. 1 and No. 2.
- With the vanity mirror cover (B) opened, there should be continuity.
- With the vanity mirror cover closed, there should be no continuity.
If the continuity is not as specified, remove the lens (C) and replace the bulb (D) or the sunvisor.