LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2012 >> Cube Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 139 (Interior Lights) >> Footwell Light Test/Replacement

Footwell Light Test/Replacement

WARNING: This page is about a different car, the 2013 Acura MDX, 2012 Acura MDX, 2011 Acura MDX, and 2010 Acura MDX. However, it is still accessible from the selected car via links, so may be relevant.
  1. Carefully pry out the footwell light lens (A) and housing (B).

    Footwell Light: 3.4 W 

    Fig 1: Identifying Footwell Light Lens, Housing, And 2P Connector
    G08055369Courtesy of AMERICAN HONDA MOTOR CO., INC.
  2. Disconnect the 2P connector (C) from the light.
  3. Check for continuity between terminals No. 1 (+) and No. 2 (-). There should be continuity. If there is no continuity, check the bulb (C). If the bulb is OK, replace the footwell light.
  4. Install the parts in the reverse order of removal.
scientia non olet · About LEMON Manuals