Side Defogger Vent Trim Removal/Installation

WARNING: This page is about a different car, the 2013 Acura MDX, 2012 Acura MDX, 2011 Acura MDX, and 2010 Acura MDX. However, it is still accessible from the selected car via links, so may be relevant.

Special Tools Required

KTC Trim Tool Set SOJATP2014*

*Available through the Acura Tool and Equipment Program, 888-424-6857

NOTE:

Take care not to scratch the dashboard or the related parts.
Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.
The driver's side defogger vent trim is shown; the passenger's side defogger vent trim is similar.

Insert the trim tool into a gap between the side defogger vent trim (A) and the dashboard (B), and release the hooks (C).

Fig 1: Inserting Trim Tool Into Gap Between Side Defogger Vent Trim And Dashboard And Hooks
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the side defogger vent trim in the reverse order of removal, and push the hooks into place securely.