Passenger's Dashboard Undercover Removal/Installation

WARNING: This page is about a different car, the 2013 Acura MDX, 2012 Acura MDX, 2011 Acura MDX, and 2010 Acura MDX. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Take care not to scratch the dashboard or the related parts.

Remove the Passenger's dashboard undercover (A).
1. Gently pull down the rear edge to detach the clips.
2. Disconnect the footwell light connector (B) and ambient light connector (C).
3. Pull the undercover away to release the pins (D) from the holders (E).
  
  Fig 1: Identifying Passenger's Dashboard Undercover Components
  Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the undercover in the reverse order of removal, and note these items:
- If the clips are damaged or stress-whitened, replace them with new ones.
- Push the clips into place securely.
- Make sure that each connector is plugged in properly.
- Make sure the pins of the undercover are installed securely to the holders.