Driver's Inner Dashboard Trim Removal/Installation

WARNING: This page is about a different car, the 2013 Acura MDX, 2012 Acura MDX, 2011 Acura MDX, and 2010 Acura MDX. However, it is still accessible from the selected car via links, so may be relevant.

Special Tools Required

KTC Trim Tool Set SOJATP2014*

*Available through the Acura Tool and Equipment Program, 888-424-6857

NOTE:

Take care not to scratch the dashboard or the related parts.
Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.

Remove the driver's inner dashboard trim (A).
1. Gently pull out along the edge beside the audio unit by hand to release the lower hooks (B) and the clip (C).
2. Detach the upper clips (D).
  
  Fig 1: Identifying Driver's Inner Dashboard Trim, Lower Hooks And Clip
  Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the trim in the reverse order of removal, and note these items:
- If the clips are damaged or stress-whitened, replace them with new ones.
- Position the hooks first on installation, then move the clips into place.
- Push the clips and the hooks into place securely.