Console Armrest Removal/Installation

WARNING: This page is about a different car, the 2013 Acura MDX, 2012 Acura MDX, 2011 Acura MDX, and 2010 Acura MDX. However, it is still accessible from the selected car via links, so may be relevant.

Special Tools Required

KTC Trim Tool Set SOJATP2014*

*Available through the Acura Tool and Equipment Program, 888-424-6857

NOTE:

Take care not to scratch the console.
Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.

Remove the center console rear trim (see CENTER CONSOLE REAR TRIM REMOVAL/INSTALLATION ).
Starting at the rear, pull out the wood panel (A) to detach the clips, then remove it.

Fig 1: Identifying Wood Panel And Clips
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Remove the screws, then remove the armrest (A) from the space between the console frame (B) and the console latch trim (C).

Fig 2: Identifying Armrest, Console Frame, Console Latch Trim And Screws
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the armrest in the reverse order of removal, and note these items:
- If the clips are damaged or stress-whitened, replace them with new ones.
- Push the clips into place securely.