Center Console Panel Pocket Replacement

WARNING: This page is about a different car, the 2013 Acura MDX, 2012 Acura MDX, 2011 Acura MDX, and 2010 Acura MDX. However, it is still accessible from the selected car via links, so may be relevant.

Special Tools Required

KTC Trim Tool Set SOJATP2014*

*Available through the Acura Tool and Equipment Program, 888-424-6857

NOTE:

Take care not to scratch the pocket.
Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.

Remove the center console (see CENTER CONSOLE REMOVAL/INSTALLATION ).
Remove the center console panel (see CENTER CONSOLE LATCH PANEL REMOVAL/INSTALLATION ).
Remove the screws, then remove the console pocket (A) from the console panel (B).

Fig 1: Identifying Console Pocket, Console Panel And Screws
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Remove the screws and release the tabs (A), then remove the upper lid (B).

Fig 2: Identifying Upper Lid, Tabs And Screws
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Remove the arm (A) and the spring (B).

Fig 3: Identifying Arm And Spring
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Remove the console pocket lid (A) from the console pocket (B).

Fig 4: Identifying Console Pocket Lid And Console Pocket
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the pocket in the reverse order of removal, and apply oil to entire rail area of the arm.