BSI Radar Unit Removal/Installation

WARNING: This page is about a different car, the 2013 Acura MDX, 2012 Acura MDX, 2011 Acura MDX, and 2010 Acura MDX. However, it is still accessible from the selected car via links, so may be relevant.

Remove the rear bumper (see FRONT BUMPER SKID TRIM REPLACEMENT ).
Disconnect the 6P connector (A) from the BSI radar unit(B).

Fig 1: Identifying 6P Connector And Radar Unit
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Remove the bolts and the BSI radar unit.
Clean the surface of the BSI radar unit.
Install the BSI radar unit (A) with the bolts.

Fig 2: Identifying BSI Radar Unit And 6P Connector
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Connect the 6P connector (B) to the BSI radar unit.
Inspect the BSI radar unit aiming