Second Row Seat-Back Recline Cable Replacement

WARNING: This page is about a different car, the 2013 Acura MDX, 2012 Acura MDX, 2011 Acura MDX, and 2010 Acura MDX. However, it is still accessible from the selected car via links, so may be relevant.

Special Tools Required

KTC Trim Tool Set SOJATP2014*

* Available through the Acura Tool and Equipment Program, 888-424-6857

NOTE:

Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.
Take care not to bend the cable.

Remove the seat-back recline lever (see SECOND ROW SEAT-BACK RECLINE LEVER REPLACEMENT ).
Carefully pry out the cover (A) with a flat-tip screwdriver at the gap while holding the lever fully open. Release the tabs (B), then remove the cover.

Fig 1: Prying Out Cover With Flat-Tip Screwdriver
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Disconnect the recline cables (A).

Fig 2: Disconnecting Recline Cables
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the cable in the reverse order of removal, and make sure the cables are connected securely.