DTC B1032: MICU Lost Communication with SRS Unit (CDS Message)
WARNING: This page is about a different car, the 2013 Acura MDX, 2012 Acura MDX, 2011 Acura MDX, and 2010 Acura MDX. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A
- Clear the DTCs with the HDS.
- Turn the ignition switch to LOCK (0) and then back to ON (II).
- Wait for at least 6 seconds.
- Check for DTCs with the HDS.
Is DTC B1032 Indicated?
YES -Go to step 5.
NO -Intermittent failure, the system is OK at this time. Check for loose or poor connections.
- Check for DTCs with the HDS.
Is DTC B1011 also indicated with DTC B1032?
YES -Check for an open in the wire between the MICU and the gauge control module. If the circuit is faulty, repair the open.
NO -Do the gauge control module input test GAUGE CONTROL MODULE INPUT TEST ).