LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2012 >> Cube Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 123 (Audio System) >> Speaker Test/Replacement >> Subwoofer (without navigation)

Subwoofer (without navigation)

WARNING: This page is about a different car, the 2013 Acura MDX, 2012 Acura MDX, 2011 Acura MDX, and 2010 Acura MDX. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the right rear side trim panel (see TRIM REMOVAL/INSTALLATION - REAR SIDE AREA ).
  2. Disconnect the 8P connector (A), then remove the bolts (B), nuts (C) and pull out the subwoofer (B).
    Fig 1: Subwoofer With Torque Specifications (Without Navigation)
    G08054267Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Measure the resistance between the terminals No. 2 and No. 7 and terminals No. 3 and No. 8. There should be about 2 Ω.
  4. If the resistance is not as specified, replace the subwoofer.
scientia non olet · About LEMON Manuals