LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2012 >> Cube Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 122 (Active Damper System) >> Vertical Acceleration Sensor Replacement >> Rear

Vertical Acceleration Sensor Replacement: Rear

WARNING: This page is about a different car, the 2013 Acura MDX, 2012 Acura MDX, 2011 Acura MDX, and 2010 Acura MDX. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the ignition switch to LOCK (0).
  2. Remove the appropriate side of the rear side trim panel (see TRIM REMOVAL/INSTALLATION - REAR SIDE AREA ).
  3. Remove the sensor mounting nuts, and pull out the vertical acceleration sensor (A).
    NOTE: The illustration shows the left side of the vehicle, the right side is similar.
    Fig 1: Vertical Acceleration Sensor With Torque Specification (Rear)
    G08052951Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Disconnect the vertical acceleration sensor connector (B).
  5. Install the vertical acceleration sensor in the reverse order of removal.
  6. Test-drive the vehicle, and check that the active damper system indicator does not come on (see ACTIVE DAMPER SYSTEM DAMPER UNITS  ).
scientia non olet · About LEMON Manuals