LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2012 >> Cube Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 12 (Clutch) >> Clutch Replacement >> Engine Side >> Flywheel Replacement

Flywheel Replacement

WARNING: This page is about a different car, the 2013 Honda Fit, 2012 Honda Fit, 2011 Honda Fit, 2010 Honda Fit, and 2009 Honda Fit. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the ring gear holder.
    Fig 1: Identifying Flywheel Mounting Bolts
    G05953320Courtesy of AMERICAN HONDA MOTOR CO., INC.
  2. Loosen the flywheel mounting bolts in a crisscross pattern in several steps. Remove the bolts, then remove the flywheel and the ring gear holder.
  3. Install the flywheel on the crankshaft, and install the mounting bolts finger-tight.
  4. Install the ring gear holder (A), then torque the flywheel mounting bolts (B) in a crisscross pattern in several steps.
    Fig 2: Identifying Ring Gear Holder & Flywheel Mounting Bolts
    G05953321Courtesy of AMERICAN HONDA MOTOR CO., INC.
scientia non olet · About LEMON Manuals