Clutch Hose Replacement

WARNING: This page is about a different car, the 2013 Honda Fit, 2012 Honda Fit, 2011 Honda Fit, 2010 Honda Fit, and 2009 Honda Fit. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Replace the clutch hose it is twisted, cracked, or if it leaks.
Use fender covers to avoid damaging painted surfaces.
Do not spill brake fluid on the vehicle; it may damage the paint or plastic. If brake fluid does contact the paint or plastic, wash it off immediately water.

Do the battery removal procedure (see BATTERY REMOVAL AND INSTALLATION ).
Remove the air cleaner housing (see AIR CLEANER REMOVAL/INSTALLATION ).
Disconnect the clutch hose (A) from the clutch lines (B).

Fig 1: Identifying Clutch Hose & Clutch Lines
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Remove and discard the clutch hose clips (A) from the clutch hose (B).

Fig 2: Identifying Clutch Hose Clips & Clutch Hose
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Remove the clutch hose from clutch hose brackets.
Install the clutch hose (A) with the new clutch hose clips (B).

Fig 3: Identifying Clutch Hose & Clutch Hose Clips
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Connect the clutch lines (A) to the clutch hose (B).

Fig 4: Identifying Clutch Lines & Clutch Hose
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Bleed the clutch hydraulic system (see CLUTCH HYDRAULIC SYSTEM BLEEDING ).
Do the following checks:
- Check the clutch hose and line joint for leaks, and tighten if necessary.
- Check the clutch hose for interference and twisting.
Install the air cleaner housing (see AIR CLEANER REMOVAL/INSTALLATION ).
Do the battery installation procedure (see BATTERY REMOVAL AND INSTALLATION ).
Test-drive the vehicle.