LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2012 >> Cube Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 116 (EVAP System) >> EVAP Canister Replacement

EVAP Canister Replacement

WARNING: This page is about a different car, the 2013 Acura MDX, 2012 Acura MDX, 2011 Acura MDX, and 2010 Acura MDX. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise the vehicle on a lift.
  2. Remove the EVAP canister cover (A).
    Fig 1: EVAP Canister Cover And Mounting Bolts With Torque Specification
    G08052691Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Disconnect the quick-connect fitting (A) (see FUEL LINE/QUICK-CONNECT FITTING PRECAUTIONS ), the hoses (B), the EVAP canister vent shut valve 2P connector (C), and the FTP sensor 3P connector (D), then remove the harness clamps (E).
    Fig 2: EVAP Canister Assembly With Torque Specifications
    G08052692Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Remove the bolts (F).
  5. Remove the EVAP canister assembly (G).
  6. Remove the EVAP canister vent shut valve (A) and the FTP sensor (B) from the canister (C).
    Fig 3: Identifying EVAP Canister Vent Shut Valve, FTP Sensor, Canister, O-Rings And Cap
    G08052693Courtesy of AMERICAN HONDA MOTOR CO., INC.
  7. Reassemble the EVAP canister vent shut valve and the FTP sensor onto the EVAP canister with new O-rings (D), a new cap (E), and a new retainer (F).
    NOTE: Do not coat the O-rings with oil.
  8. Install the parts in the reverse order of removal.
scientia non olet · About LEMON Manuals