DTCs (if the aiming is incomplete)
WARNING: This page is about a different car, the 2013 Acura MDX, 2012 Acura MDX, 2011 Acura MDX, and 2010 Acura MDX. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
If the aiming is incomplete, the MID indicates a DTC. The ACC unit does not store the DTC, and you cannot read the DTCs with the HDS, so note the DTC before cycling the ignition key.
| DTC indication (on the MID) | Cause | How to solve |
|---|---|---|
| DTC 120 | Two or more aiming targets exist. | Remove all reflective objects except the correct special tools, and repeat the aiming procedure. |
| DTC 121 | The width of the aiming target is out of, specification. | Use the genuine aiming target, and repeat the aiming procedure. |
| DTC 122 | The distance of the aiming target is out of specification. | Set the distance to the aiming target 16.0-16.7 ft (4.9-5.1 m), and repeat the aiming procedure. |
| DTC 123 | The aiming target is moved. | Do the aiming procedure again. |
| DTC 124 | The right and left position of the aiming target is out of specification. | Reset the aiming target at the correct position, and repeat the aiming procedure. |