DTC 62: Millimeter Wave Radar Sensor Error
WARNING: This page is about a different car, the 2013 Acura MDX, 2012 Acura MDX, 2011 Acura MDX, and 2010 Acura MDX. However, it is still accessible from the selected car via links, so may be relevant.
- Clear the DTCs with the HDS (see HOW TO CLEAR DTCS ).
- Turn the ignition switch to ON (II), then wait for 10 seconds, and press the MAIN switch ON.
- Watch the ACC indicator and the CMBS indicators.
Do both indicators come on?
YES -Go to step 4.
NO -Intermittent failure, the system is OK at this time.
- Check for DTCs with the HDS (see HOW TO CLEAR DTCS
).
Is DTC 62 indicated?
YES -Check for loose or poor connections. If OK, replace the millimeter wave radar (see MILLIMETER WAVE RADAR REMOVAL/INSTALLATION ). After replacement, aim the millimeter wave radar (see MILLIMETER WAVE RADAR AIMING ).
NO -Intermittent failure, the system is OK at this time.