Body Side Clip Replacement

WARNING: This page is about a different car, the 2013 Acura MDX, 2012 Acura MDX, 2011 Acura MDX, and 2010 Acura MDX. However, it is still accessible from the selected car via links, so may be relevant.

Gradually scrape off the adhesive tape (A) under the clips (B) while heating it with a heat gun to 212-248°F (100-120°C).
NOTE:
- To prevent damage, do not heat the painted surface around the clips too much.
- To keep the exterior resin parts near the A-pillar from being overheated by the heat gun, wrap them with aluminum foil.
  
  Fig 1: Locating Adhesive Tape And Clips
  Courtesy of AMERICAN HONDA MOTOR CO., INC.
Clean the body bonding surface with a sponge dampened in isopropyl alcohol. After cleaning, keep oil, grease, and water from getting on the surface.
Install the clips (A).
1. Peel the adhesive backing away from the clips.
2. Line up the clips with the alignment marks (B) on the body, and attach the clips with adhesive tape (C).
3. Apply two-part epoxy adhesive (D) around the edge of the clips as shown.
  Adhesive tape: Thickness 1 mm (0.04 in) Width 8 mm (0.32 in)
  
  Fig 2: Locating Clips And Alignment Marks On Body
  Courtesy of AMERICAN HONDA MOTOR CO., INC.