A-Pillar Corner Trim Replacement

WARNING: This page is about a different car, the 2013 Acura MDX, 2012 Acura MDX, 2011 Acura MDX, and 2010 Acura MDX. However, it is still accessible from the selected car via links, so may be relevant.

Special Tools Required

KTC Trim Tool Set SOJATP2014*

*Available through the Acura Tool and Equipment Program, 888-424-6857

NOTE:

Take care not to scratch the trim or the body.
Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.

Open the front door.
Using a trim tool, detach the bottom clip of the A-pillar corner trim (A).

Fig 1: Identifying A-Pillar Corner Trim Fastener Locations
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Gently slide the A-pillar corner trim (A) up along the A-pillar to release it from the clips.

Fig 2: Locating A-Pillar Corner Trim
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Using a trim tool, remove the clips from the body.
If the clips are damaged or stress-whitened, replace them with new ones.
Install the clips (A) on the A-pillar corner trim (B).

Fig 3: Locating Clips And A-Pillar Corner Trim
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Hold the A-pillar corner trim (A) up, and fit the clips into the holes in the body, then push on the trim until the clips snap into place securely.

Fig 4: Identifying A-Pillar Corner Trim Fastener Location
Courtesy of AMERICAN HONDA MOTOR CO., INC.