Rear Engine Mount Removal and Installation: Removal

WARNING: This page is about a different car, the 2013 Acura MDX, 2012 Acura MDX, 2011 Acura MDX, and 2010 Acura MDX. However, it is still accessible from the selected car via links, so may be relevant.

Remove the rear engine mount stop (A), then remove the rear engine mount bolt (B).

Fig 1: Locating Rear Engine Mount Stop And Rear Engine Mount Bolt
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Raise the vehicle on the lift.
Remove the rear warm up TWC (see REAR (BANK 1) ).
Remove the power steering line bracket (A), then remove the rear engine mount base mounting bolts (B).

Fig 2: Locating Power Steering Line Bracket And Rear Engine Mount Base Mounting Bolts
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Lift and support the engine with a jack and a wood block under the engine/transmission.
Remove the rear engine mount (C) with the rear engine mount base (D).
Remove the rear engine mount from the rear engine mount base.