Special Tools Required

WARNING: This page is about a different car, the 2013 Acura MDX, 2012 Acura MDX, 2011 Acura MDX, and 2010 Acura MDX. However, it is still accessible from the selected car via links, so may be relevant.

Back Probe Adapter, 17 mm 07TAZ-001020A

Make sure the battery is fully charged when doing electrical test. If the battery is not fully charged, the results of the tests may not be accurate.
When using electrical test equipment, insert the probe of the tester into the wire side of the connector (except waterproof connectors). Do not insert the probe of the tester into the terminal side of the connector, and do not tamper with the connector.

Fig 1: Precautions For Electrical Inspections (1 Of 2)
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Use back probe adaptor, 17 mm (07TAZ-001020A). Do not insert the probe forcibly.

Fig 2: Precautions For Electrical Inspections (2 Of 2)
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Use specified service connectors in troubleshooting. Using improper tools could cause a diagnostic error due to poor metal-to-metal contact.