LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2012 >> Cube Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 103 (SRS (Supplemental Restraint System)) >> Driver's Airbag Replacement >> Removal

Driver's Airbag Replacement: Removal

WARNING: This page is about a different car, the 2013 Acura MDX, 2012 Acura MDX, 2011 Acura MDX, and 2010 Acura MDX. However, it is still accessible from the selected car via links, so may be relevant.
  1. Do the battery terminal disconnection procedure (see USING THE GR8 BATTERY DIAGNOSTIC STATION ), then wait at least 3 minutes before starting work.
  2. Remove the access panel (A) from the steering wheel, then disconnect the driver's airbag 4P connector (B) from the cable reel 4P connector.
    Fig 1: Identifying Access Panel, Driver's Airbag 4P Connector And Horn Switch 1P Connector
    G08058497Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Disconnect the horn switch 1P connector (C).
  4. Remove the two TORX bolts (A) using a TORX T30 bit.
    Fig 2: Identifying TORX Bolts And Driver's Airbag
    G08058498Courtesy of AMERICAN HONDA MOTOR CO., INC.
  5. Remove the driver's airbag (B).
scientia non olet · About LEMON Manuals