LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2012 >> Cube Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 102 (Exterior Lights) >> Brake Pedal Position Switch Test

Brake Pedal Position Switch Test

WARNING: This page is about a different car, the 2013 Acura MDX, 2012 Acura MDX, 2011 Acura MDX, and 2010 Acura MDX. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the 4P connector (A) from the brake pedal position switch (B).
    Fig 1: Identifying 4P Connector And Brake Pedal Position Switch
    G08055336Courtesy of AMERICAN HONDA MOTOR CO., INC.
  2. Check for continuity between terminals No. 1 and No. 2.
    • There should be continuity when the brake pedal is pressed.
    • There should be no continuity when the brake pedal is released.
  3. Check for continuity between terminals No. 3 and No. 4.
    • There should be no continuity when the brake pedal is pressed.
    • There should be continuity when the brake pedal is released.
  4. If necessary, adjust the pedal height (see BRAKE PEDAL AND BRAKE PEDAL POSITION SWITCH ADJUSTMENT ), or replace the switch.
scientia non olet · About LEMON Manuals