Rear Air Outlet Replacement

WARNING: This page is about a different car, the 2013 Acura MDX, 2012 Acura MDX, 2011 Acura MDX, and 2010 Acura MDX. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Take care not to scratch the body.

Remove the rear bumper (see FRONT BUMPER SKID TRIM REPLACEMENT ).
Detach the hooks (A), then remove the rear air outlet (B).

Fig 1: Locating Hooks And Rear Air Outlet
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the air outlet by pushing on the hook areas until the hooks snap into place.