Engine-Start Effect Function
For CVT Models
When "engine start" is read, the effect of comfort starts only once by turning on combination meter illumination stepwise and sweeping the needles of speedometer and tachometer.
For M/T Models
When "engine start" is read, the effect of comfort starts only once by turning on combination meter illumination and start-up lamp stepwise and sweeping the needles of speedometer and tachometer.
Outline of Control System
System control is provided when all of the following conditions are met.
| Operating condition | Signal name | Signal source | |||
|---|---|---|---|---|---|
| Ignition switch | ON | Ignition signal | - | ||
| Shift position(1) | P-range | Shift position signal (CAN communication) | TCM | ||
| Engine status | More than 500 rpm | Engine speed signal (CAN communication) | ECM | ||
| Except when cranking | Engine status signal (CAN communication) | ||||
| Vehicle speed | Less than 1 km/h (0.6 MPH) | Vehicle speed signal (CAN communication) | ABS actuator and electric unit (control unit) | ||
|
|||||
NOTE:
The engine-start effect function ends if any one of the above conditions is lost during the activation of this function.