Diagnosis Procedure
- CHECK WASHER LEVEL SWITCH SIGNAL CIRCUIT
- Turn ignition switch OFF.
- Disconnect combination meter connector and washer level switch connector.
- Check continuity between combination meter harness connector and washer level switch harness connector.
Terminals Continuity Combination meter Washer level switch Connector Terminal Connector Terminal M34 17 E52 1 Existed - Check continuity between combination meter harness connector and ground.
Terminals Continuity Combination meter Ground Connector Terminal M34 17 Not existed Is the inspection result normal?
YES >> GO TO 2.
NO >> Repair harness or connector.
- CHECK WASHER LEVEL SWITCH GROUND CIRCUIT
Check continuity between washer level switch connector and ground.
Terminals Continuity Washer level switch Ground Connector Terminal E52 2 Existed Is the inspection result normal?
YES >> INSPECTION END
NO >> Repair harness or connector.