COMBINATION METER: Diagnosis Procedure
- CHECK FUSE
Check for blown fuses.
Power source Fuse No. Battery 11 Ignition switch ACC or ON 20 Ignition switch ON or START 3 Is the inspection result normal?
YES >> GO TO 2.
NO >> Be sure to eliminate cause of malfunction before installing new fuse.
- CHECK POWER SUPPLY CIRCUIT
Check voltage between combination meter harness connector and ground.
Terminals Ignition switch position Voltage (Approx.) (+) (-) Combination meter Ground Connector Terminal M34 27 OFF Battery voltage 15 ACC 28 ON Is the inspection result normal?
YES >> GO TO 3.
NO >> Check harness between combination meter and fuse.
- CHECK GROUND CIRCUIT
- Turn ignition switch OFF.
- Disconnect combination meter connector.
- Check continuity between combination meter harness connector and ground.
Combination meter Ground Continuity Connector Terminal M34 22 Existed 23 Is the inspection result normal?
YES >> INSPECTION END
NO >> Repair harness or connector.