Physical Values
| Terminal | Wire color | Item | Condition | Reference value (V) (Approx.) | |
|---|---|---|---|---|---|
| Ignition switch | Operation or condition | ||||
| 1 | W/L | Battery power supply | - | - | Battery voltage |
| 2 | O | Ignition switch ON or START | ON | - | Battery voltage |
| 3 | B | Ground (Power) | - | - | 0 |
| 4 | B | Ground (Illumination) | |||
| 5 | R/Y | Illumination output | - | - | Refer to "SYSTEM DESCRIPTION ". |
| 9 | GR/W | Illumination switch power | - | - | |
| 10 | O/L | Mode switch ground | ON | - | 0 |
| 11 | L/R | Mode switch A | ON | Switch pressed | 0 |
| Switch released | 5 | ||||
| 12 | B/R | Mode switch B | ON | Switch pressed | 0 |
| Switch released | 5 | ||||
| 14 | V/Y | Ignition switch ACC or ON | ON | - | Battery voltage |
| 15 | BR/W | Air bag warning lamp input | ON | Air bag warning lamp ON | 3 |
| Air bag warning lamp OFF | 0 | ||||
| 16 | G/W | Water temperature output | ON | At idle [after warming up, approx. 80°C (176°F)]
NOTE:
The wave forms vary depending on coolant temperature.
|
|
| 17 | R/W | AC PD CUT | ON | Signal ON | 0 |
| Signal OFF | 5 | ||||
| 18 | O/B | Ambient sensor signal | ON | - | 0 - 5 (Based on ambient temperature) |
| 19 | P | Ambient sensor VDD | ON | - | 5 |
| 20 | B/Y | Ambient sensor ground | ON | - | 0 |
| 21 | L | CAN-H | - | - | - |
| 22 | P | CAN-L | - | - | - |
| 23 | B | Ground (Circuit) | - | - | 0 |
| 24 | B/W | Fuel level sensor ground | ON | - | 0 |
| 25 | BR | Generator | ON | Generator voltage low | 0 |
| Generator voltage normal | Battery voltage | ||||
| 26 | G/R | Parking brake switch | ON | Parking brake depressed | 0 |
| Parking brake released | Battery voltage | ||||
| 27 | V | Brake fluid level switch | ON | Brake fluid level low | 0 |
| Brake fluid level normal | Battery voltage | ||||
| 28 | L/O | Security indicator input | OFF | Security indicator ON | 0 |
| Security indicator OFF | Battery voltage | ||||
| 29 | R | Washer fluid level switch | ON | Washer fluid level low | 0 |
| Washer fluid level normal | Battery voltage | ||||
| 30 | L/B | Vehicle speed signal output (2-pulse) | ON | Speedometer operated [When vehicle speed is approx. 20 km/h (12 MPH)] | 240 Hz |
| 31 | V/W | Vehicle speed signal output (8-pulse) | ON | Speedometer operated [When vehicle speed is approx. 40 km/h (25 MPH)] |
NOTE:
Maximum voltage may be 12V due to specifications (connected units).
|
| 34 | G/B | Fuel level sensor signal | - | - | Refer to "FUEL GAUGE: SYSTEM DESCRIPTION ". |
| 35 | W/B | Seat belt buckle switch LH | ON | Unfastened (ON) | 0 |
| Fastened (OFF) | Battery voltage | ||||
| 36 | L/W | Seat belt buckle switch RH | ON | Unfastened (ON) | 0 |
| Fastened (OFF) | Battery voltage | ||||
| 37 | G | Not M range | ON | Manual mode switch OFF | 0 |
| Manual mode switch ON | Battery voltage | ||||
| 38 | BR | CVT shift down | ON |
|
0 |
| Other than above | Battery voltage | ||||
| 39 | W | CVT shift up | ON |
|
0 |
| Other than above | Battery voltage | ||||
| 40 | LG/R | M range | ON | Manual mode switch OFF | Battery voltage |
| Manual mode switch ON | 0 | ||||