Removal and Installation of Rear Oil Seal: Installation

Apply the liquid gasket lightly to entire outside area of new rear oil seal.
Use Genuine Silicone RTV Sealant or equivalent. Refer to "RECOMMENDED CHEMICAL PRODUCT AND SEALANT ".
Install rear oil seal so that each seal lip is oriented as shown in the figure.

Fig 1: Installing Rear Oil Seal
Courtesy of NISSAN MOTOR CO., U.S.A.
- Install rear oil seal with a suitable tool with an outer diameter 115 mm (4.53 in) and inner diameter 90 mm (3.54 in) (A).
  CAUTION:
  - Be careful not to damage crankshaft and cylinder block.
  - Press-fit oil seal straight to avoid causing burrs or tilting.
  - Do not touch grease applied onto oil seal lip.
    
    Fig 2: Installing Rear Oil Seal With Suitable Tool
    Courtesy of NISSAN MOTOR CO., U.S.A.
- Install rear oil seal (1) to the position as shown in the figure.
  
  Fig 3: View Of Proper Rear Oil Seal Installation Orientation
  Courtesy of NISSAN MOTOR CO., U.S.A.
  
  NOTE: The standard surface of the dimension is the rear end surface of cylinder block.
Installation of the remaining components is in the reverse order of removal.