Cluster Lid C

Removal

1. Remove the M/T or CVT shift selector handle. Refer to "REMOVAL AND INSTALLATION " (M/TRS6F94R), "REMOVAL AND INSTALLATION " (M/T-RS6F52A), "REMOVAL AND INSTALLATION " (M/TRS6F52H) or "SHIFT SELECTOR HANDLE REMOVAL AND INSTALLATION " (CVT).
2. Release the M/T or CVT finisher, disconnect necessary connectors, and remove finisher. Refer to "COMPONENT PARTS "
3. Remove the cluster lid C upper mask (non SE-R models). Refer to "COMPONENT PARTS "
4. Remove the double meter (SE-R models). Refer to "REMOVAL AND INSTALLATION "
5. Remove cluster lid C (1).
   1. Remove cluster lid C screws (A).
   2. Pull out cluster lid C (1) to disconnect harness connector and remove cluster lid C (1).
      Fig 1: Identifying Cluster Lid C And Cluster Lid C Screws

      Courtesy of NISSAN MOTOR CO., U.S.A.

Installation

Installation is in the reverse order of removal.