Baulk Ring Clearance
WARNING: This page is about a different variant/trim than selected.
BAULK RING CLEARANCE
| Unit: mm (in) | |||
|---|---|---|---|
| Measurement point | Standard value | Limit value | |
| 3rd (Double-cone synchronizer) | Clearance between synchronizer cone and inner baulk ring end face (A) | 0.6 - 0.8 (0.024 - 0.031) | 0.2 (0.008) |
| Clearance between outer baulk ring pawl and synchronizer cone (B) | 0.6 - 1.1 (0.024 -0.043) | 0.2 (0.008) | |
| 1st and 2nd (Triple-cone synchronizer) | Clearance between synchronizer cone and clutch gear end face (A) | 0.6 - 1.2 (0.024 - 0.047) | 0.3 (0.012) |
| Clearance between outer baulk ring pawl and synchronizer cone (B) | 0.6 - 1.1 (0.024 - 0.043) | 0.2 (0.008) | |
| Clearance between inner baulk ring and clutch gear end face (C) | 0.7 - 1.1 (0.028 - 0.043) | 0.3 (0.012) | |
| 4th | 0.9 - 1.45 (0.035 - 0.057) | 0.7 (0.028) | |
| 5th | 0.95 - 1.4 (0.037 - 0.055) | 0.7 (0.028) | |
| 6th | 0.95 - 1.4 (0.037 - 0.055) | 0.7 (0.028) | |
| Reverse | 0.95 - 1.4 (0.037 - 0.055) | 0.7 (0.028) | |