Disassembly and Assembly: Assembly

WARNING: This page is about a different variant/trim than selected.

Press in differential side bearing (transaxle case side) to differential case using Tools.
Tool number : KV38102510 (-) : ST30720000 (J-25405)

CAUTION: Replace differential side bearing and differential side bearing outer race as a set.
Align and install speedometer drive gear onto differential case.

Fig 1: Installing Speedometer Drive Gear Onto Differential Case
Courtesy of NISSAN MOTOR CO., U.S.A.
Press in differential side bearing (clutch housing side) to differential case using Tools.
Tool number A: ST30720000 (J-25405)

B: KV38102510 (-)

Fig 2: Pressing In Differential Side Bearing (Clutch Housing Side) To Differential Case Using Tools
Courtesy of NISSAN MOTOR CO., U.S.A.
CAUTION:
- Do not reuse differential side bearing and differential side bearing outer race.
- Replace differential side bearing and differential side bearing outer race as a set.
Install final gear into differential case and tighten final gear bolts to the specified torque. Refer to "DISASSEMBLY AND ASSEMBLY ".

Fig 3: Installing Final Gear Into Differential Case
Courtesy of NISSAN MOTOR CO., U.S.A.