Inspection After Disassembly

Striking Rod Assembly and Return Spring

• Check contact surfaces and sliding area for wear, damage, bending, etc. If necessary, replace parts.
  Fig 1: Checking Contact Surfaces And Sliding Area

  Courtesy of NISSAN MOTOR CO., U.S.A.

Fork Rod and Shift Fork

• Check contact surfaces and sliding area for wear, damage, bending, etc. If necessary, replace parts.
  Fig 2: Checking Contact Surfaces And Sliding Area For Wear, Damage, Bending

  Courtesy of NISSAN MOTOR CO., U.S.A.
• Check if the width of shift fork hook (sliding area with coupling sleeve) is within allowable specification below.
  ITEM DIMENSIONS
  
  

  Item	One-side wear specification	Sliding width of new part
  1st-2nd	0.2 mm (0.008 in)	7.80 - 7.93 mm (0.3071 - 0.3122 in)
  3rd-4th	0.2 mm (0.008 in)	7.80 - 7.93 mm (0.3071 - 0.3122 in)
  5th-6th	0.2 mm (0.008 in)	6.10 - 6.23 mm (0.2402 - 0.2453 in)
  Reverse	0.2 mm (0.008 in)	12.80 - 12.93 mm (0.5039 - 0.5091 in)

  Fig 3: Identifying Shift Fork Hook

  Courtesy of NISSAN MOTOR CO., U.S.A.