Disassembly and Assembly: Disassembly

WARNING: This page is about a different variant/trim than selected.

Before disassembling, measure the end play of 1st and 2nd main gears.
End play standard value : Refer to "GEAR END PLAY ".

Fig 1: Checking Gear End Play
Courtesy of NISSAN MOTOR CO., U.S.A.
Remove snap ring.
Remove C-ring holder and then remove mainshaft C-rings.

Fig 2: Removing C-Ring Holder
Courtesy of NISSAN MOTOR CO., U.S.A.
Press out mainshaft rear bearing, 6th main gear adjusting shim, and 6th main gear using Tool and a puller.
Tool number :ST33052000 (-)
Remove 5th-6th mainshaft spacer.

Fig 3: Removing 5th-6th Mainshaft Spacer
Courtesy of NISSAN MOTOR CO., U.S.A.
Press out 4th main gear and 5th main gear using Tool and a puller.
Tool number :ST33052000 (-)
Remove 4th main gear adjusting shim.
Remove 3rd-4th mainshaft spacer.

Fig 4: Removing 3rd-4th Mainshaft Spacer
Courtesy of NISSAN MOTOR CO., U.S.A.
Press out 3rd main gear and 2nd main gear using Tool (A) and a puller (B).
Tool number A: KV40105020 (-)
Remove 2nd needle bearing.

Fig 5: Removing 2nd Needle Bearing
Courtesy of NISSAN MOTOR CO., U.S.A.
Press out 2nd main gear bushing, 1st-2nd synchronizer hub assembly, 1st main gear, 1st needle bearing, 1st main gear bushing, and reverse main gear using Tool (A).
Tool number A: KV40105020 (-)

Fig 6: Pressing Out 2nd Main Gear Bushing, 1st-2nd Synchronizer Hub Assembly
Courtesy of NISSAN MOTOR CO., U.S.A.