Changing M/T Oil: Filling
WARNING: This page is about a different variant/trim than selected.
- Remove plug (1). Fill the transaxle with new oil and check the oil level (L) using suitable gauge (A) as shown in the figure.
Oil grade and capacity : Refer to "QR25DE ".
Oil level (L) : 61.0 - 67.0 mm (2.402 - 2.638 in)
- Set an O-ring on plug (1) and then install it to transaxle. Tighten to the specified torque. Refer to
"DISASSEMBLY AND ASSEMBLY ".CAUTION: Do not reuse O-ring.