Disassembly and Assembly: Pre-Inspection

WARNING: This page is about a different variant/trim than selected.

Clean final drive assembly sufficiently to prevent side gear thrust washer, differential case, side gear, and other parts from sticking by gear oil.
Put differential case vertically so that side gear to be measured faces upward.
Place Tool and a dial indicator onto side gear.
Tool number : - (J-39713)

Fig 1: Placing Tool And Dial Indicator Onto Side Gear
Courtesy of NISSAN MOTOR CO., U.S.A.
Move side gear up and down, and measure the clearance.
Allowable Clearance between side gear and differential case with thrust washer : Refer to "AVAILABLE THRUST WASHER ".

Fig 2: Measuring Clearance Between Side Gear And Differential Case With Thrust Washer
Courtesy of NISSAN MOTOR CO., U.S.A.

CAUTION: There should be no resistance and gears should rotate freely.
If not within specification, adjust the clearance by changing side gear thrust washer thickness.
Turn differential case upside down and measure the clearance between side gear and differential case on the other side in the same way.