LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2011 >> Sentra S >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Manual Transmission - RS6F52A) >> Service Information >> Final Drive >> Disassembly and Assembly >> Disassembly

Disassembly and Assembly: Disassembly

WARNING: This page is about a different variant/trim than selected.
  1. Remove final gear bolts and then separate the final gear from differential case.
  2. Remove differential side bearing (clutch housing side) using Tool (A) and pullers (B).

    Tool number A: ST33061000 (J-8107-2) 

    CAUTION: Hook a puller on the cage of differential side bearing.
  3. Remove speedometer drive gear.
    Fig 1: Removing Speedometer Drive Gear
    G07138808Courtesy of NISSAN MOTOR CO., U.S.A.
  4. Remove differential side bearing (transaxle case side) using Tool and puller.

    Tool number : ST33061000 (J-8107-2) 

    CAUTION: Hook a puller on the inner race of differential side bearing.
    Fig 2: Removing Differential Side Bearing (Transaxle Case Side) Using Tool And Puller
    G07138809Courtesy of NISSAN MOTOR CO., U.S.A.
  5. Remove retaining pin from differential case using suitable tool and then remove pinion mate shaft.
  6. Rotate pinion mate gears and remove pinion mate gears, pinion mate thrust washers, side gears, and side gear thrust washers from differential case.
    Fig 3: Removing Retaining Pin From Differential Case Using Suitable Tool
    G07138810Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About LEMON Manuals