LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2011 >> Sentra S >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Manual Transmission - RS6F52A) >> Service Information >> Control Linkage >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Remove battery. Refer to "REMOVAL AND INSTALLATION (QR25DE BATTERY) ".
  2. Remove air cleaner and air duct. Refer to "REMOVAL AND INSTALLATION ".
  3. Remove shift cable from shifter lever as shown in the figure.
    Fig 1: Removing Shift Cable From Shifter Lever
    G07138633Courtesy of NISSAN MOTOR CO., U.S.A.
  4. Remove select cable from selector lever A as shown in the figure.
    Fig 2: Removing Select Cable From Selector Lever
    G07138634Courtesy of NISSAN MOTOR CO., U.S.A.
  5. Move shift selector to neutral position.
  6. Remove shift selector handle.
  7. Remove center console assembly. Refer to "REMOVAL AND INSTALLATION ".
  8. Remove shift selector assembly nuts.
  9. Remove exhaust front tube, center muffler and heat shield. Refer to "REMOVAL AND INSTALLATION ".
  10. Remove cable support bracket.
  11. Remove select cable and shift cable from cable bracket.
  12. Remove shift selector assembly from the vehicle.
scientia non olet · About LEMON Manuals