LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2011 >> Sentra S >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Engine Lubrication System (Qr25DE)) >> Service Information >> Oil Cooler >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Drain engine oil. Refer to "CHANGING ENGINE OIL ".
  2. Drain engine coolant. Refer to "CHANGING ENGINE COOLANT ".
    CAUTION: Do not spill coolant on the drive belt.
  3. Remove the RH front wheel and tire. Refer to "ADJUSTMENT ".
  4. Remove the splash shield RH. Refer to "COMPONENT ".
  5. Disconnect the oil pressure sensor.
  6. Remove the front exhaust tube. Refer to "COMPONENT ".
  7. Disconnect water hoses from oil cooler.
    NOTE:
    • For reference during installation, put matching marks on oil cooler hoses.
    • Cap or plug opening(s) to prevent fluid from spilling.
  8. Remove oil cooler.
  9. Remove oil pressure sensor, if necessary.
scientia non olet · About LEMON Manuals