Inspection After Removal
WARNING: This page is about a different variant/trim than selected.
- Place a thread so that it is caught in the valves of the thermostat. Immerse fully in a container filled with water. Heat while stirring.
- The valve opening temperature is the temperature at which the valve opens and the thermostat falls from the thread.
- Continue heating. Check the full-open valve lift amount.NOTE: The full-open valve lift amount standard temperature for the thermostat is the reference value.
- After checking the full-open valve lift amount, lower the water temperature and check the valve closing temperature.VALVE LIFT AMOUNT SPECIFICATIONS
Items Thermostat Valve opening temperature 80.5 - 83.5°C (177 - 182°F) Full-open valve lift amount More than 8 mm/95°C (0.315 in/203°F) Valve closing temperature 77°C (171°F) - If out of the specification, replace thermostat.