Removal Of Liquid Gasket Sealing

WARNING: This page is about a different variant/trim than selected.

After removing nuts and bolts, separate the mating surface, using Tool and remove old liquid gasket sealing.
Tool number : KV10111100 (J-37228)

CAUTION: Be careful not to damage the mating surfaces.
Tap (1) Tool to insert it, and then slide (2) it by tapping on the side as shown in the figure.
In areas where Tool is difficult to use, use plastic hammer to lightly tap the part, to remove it.
CAUTION: If for some unavoidable reason suitable tool such as screwdriver is used, be careful not to damage the mating surfaces.

Fig 1: Tapping Oil Pan
Courtesy of NISSAN MOTOR CO., U.S.A.