Liquid Gasket Application Procedure

WARNING: This page is about a different variant/trim than selected.

Remove old liquid gasket adhering to the liquid gasket application surface and the mating surface, Using scraper.
- Remove liquid gasket completely from the groove of the liquid gasket application surface, bolts, and bolt holes.
Thoroughly clean the mating surfaces and remove adhering moisture, grease and foreign materials.

Fig 1: Removing Liquid Gasket
Courtesy of NISSAN MOTOR CO., U.S.A.
Attach liquid gasket tube to Tool.
Tool number : WS39930000 (-)

Use Genuine RTV Silicone Sealant or equivalent. Refer to "RECOMMENDED CHEMICAL PRODUCT AND SEALANT ".
Apply liquid gasket without breaks to the specified location with the specified dimensions.
- If there is a groove for the liquid gasket application, apply liquid gasket to the groove.
  
  Fig 2: Applying Liquid Gasket
  Courtesy of NISSAN MOTOR CO., U.S.A.
- As for the bolt holes, normally apply liquid gasket inside the holes. Occasionally, it should be applied outside the holes. Make sure to read the text of service Information.
- Within five minutes of liquid gasket application, install the mating component.
- If liquid gasket protrudes, wipe it off immediately.
- Do not retighten nuts or bolts after the installation.
- After 30 minutes or more have passed from the installation, fill engine oil and engine coolant.
  
  Fig 3: Locating Sealant Outside Of Holes
  Courtesy of NISSAN MOTOR CO., U.S.A.
CAUTION: If there are specific instructions in this information, observe them.